Automation
Non-Destructive Testing (NDT) is basic to guaranteeing that defects in welds are identified on a sequential construction system preceding being put to utilize. That is the place NDT assumes an imperative job. It can distinguish both surface and sub-surface Read more…
QA/QC activities ensure that all the defined processes are precisely and appropriately defined. Generating a standard for the procedure and fixing of proper methodology are are examples of QA activities. The QA authority will focus on reviewing all the process Read more…
FXI technologies were founded in 2006 but have ceased operations since then, this page will serve as an archive/reference of all products and technology that they represented and built. FXI Technologies was offering the world’s first any screen microcomputer – Read more…
In Industrial Automation, generally when people say ‘interposing relay’ it means a general purpose relay that is used for interposing, meaning to separate or put a barrier between two circuits. Interposing relay normally consists of a coil that is energized Read more…
Function Block Diagram (FBD) IEC-61131-3 IEC 61131-3 is an international standard first published in December 1993 by the IEC. This standard defines Two Graphical and Two Textual Controller Programming language standards. Figure 1-0. IEC Programming Languages Summary The Function Block Read more…
Proximity sensor is a device that detects objects within its vicinity without any physical contact up to nominal range. A proximity sensor often emits or radiates a signal in the form of electromagnetic radiation and looks for changes in it Read more…
There is much doubt on this topic PTO and PWM. The Engineers using μ -controllers refer to Pulse Width Modulation regardless, if it is PTO or PWM. For PLCs it is important to know the difference. The automation training Read more…
Introduction The CAN bus was developed by BOSCH as a multi-master, message broadcast system that specifies a maximum signaling rate of 1 megabit per second (bps). Unlike a traditional network such as USB or Ethernet, CAN does not send large Read more…
Encoder Working Principle: The Optical Encoders typically consist of a rotating and a stationary electronic circuit. The rotor is usually a metal, glass, or a plastic disc mounted on the encoder shaft. The disc has some kind of optical pattern, Read more…
WHY DO WE NEED SINGLE PHASE PREVENTERS The major cause of maximum motors burnout is overloading which occurs due to unbalance supply or single phasing. Phase failure occurs in case of fuse blown-off, loose connections or loss of phase from Read more…