Tag: Automation course in kochi


An important component of motion control systems is nothing but encoders. An encoder sends feedback signal to the controller to determine factors such as position, speed, count and direction. Resolution, accuracy and precision are the important terms used to describe Read more…


Recipes are a valuable property when manufacturing a product that represents a brand. It is not just a list of specific quantities of ingredients. They can be called as formulations. In recipe management, the formulations comes first followed by the Read more…


PLCs emerged as a reliable alternative to the relay logic. Earlier, the highly distributed and hardwired process control systems in a factory used relays, timers and electrical loop controllers. As you can imagine, monitoring these systems was very time consuming. Read more…


  Non-Destructive Testing (NDT) is basic to guaranteeing that defects in welds are identified on a sequential construction system preceding being put to utilize. That is the place NDT assumes an imperative job. It can distinguish both surface and sub-surface Read more…


A fire alarm is a unit made of many devices, which uses visual and audio signal to warn people about a possible fire, smoke, or carbon monoxide occurrence in the region of coverage. Fire alarms are usually set in fire Read more…


A fire extinguisher is an active fire protection device used to extinguish fires, often in emergency situations. It is not intended for use on an out-of-control fire, such as one which has reached the ceiling, endangers the user or otherwise requires the expertise of a fire Read more…


A temperature transmitter is a device that connects a temperature sensor to transmit the signal for monitoring and control purposes. Typically, the temperature sensor is either RTD, Thermistor or Thermocouple type sensor and will interface with a PLC, DCS. Temperature Read more…


For industrial facilities, the solution is tons. Industrial buildings square measure perpetually running multiple systems that eat up energy and increase utility bills, most of that square measure extraordinarily inefficient. In fact, studies show industrial buildings will scale back energy Read more…


Introduction Embossing is a stamping process for producing raised or sunken designs in sheet, metal, leather, etc. This process can be made by means of matched two dies like male and female, or by passing sheet or a strip of Read more…


The circuital arrangement of electrical fan mainly having one starting winding and one running winding called stator, and a rotor is used. One capacitor is serially connected with the starting winding, and the supply to these windings are controlled by Read more…

Find Us

Address
123 Main Street
New York, NY 10001

Hours
Monday—Friday: 9:00AM–5:00PM
Saturday & Sunday: 11:00AM–3:00PM

About This Site

This may be a good place to introduce yourself and your site or include some credits.

Find Us

Address
123 Main Street
New York, NY 10001

Hours
Monday—Friday: 9:00AM–5:00PM
Saturday & Sunday: 11:00AM–3:00PM

About This Site

This may be a good place to introduce yourself and your site or include some credits.